summones on with a repaired 30k resistor won't read??

hi guys:)

doin a v12 that i killed one of the 303 resistors a while back, so i ordered some metal film 30k resistors and replaced it using some kynar to add extra length and to prevent shorts.

i tested it and it all booted up great, i then wen't back and applied summones using anothe 560 metal film resistor it now tries to spin up in short bursts but won't actually boot.:banghead:

removed the 560, all boots fine again?? reapplied the 560 around 3 times and still the same. is it worth just leaving it off, or am i asking for a burnt laser there:chinscrat

cheers for your time

P:)

wHY DONT you exchange it with 100k or 130k resistor and dont have this summ0ne fix mess?

When i get 303 in now, i pop them out and replace with 100k, then no summ0ne fix needed on tracking.

303 = crap.
Dont leave it this way!! I can smell the a ****ed laser :)

i only have 30k resistors m8 and the ones to actually do summ0nes.

do i have to arrange them in a different way or anything??

can i make something up in series with what i have?? 30k, 560 and 1k8??

P:)

could i put 3 or 4 30k's in series instead of the one 100k or 130k??

P:)