The above video goes away if you are a member and logged in, so log in now!
Strange problem with my pstwo slim with modbo chip
Strange problem with my pstwo slim with modbo chip –
I have a pstwo slim (pal v12) with modbo 1.1 chip and diode and pic fix, the strage thing is that it wont turn on unless i take the power plug out and put it back in again then turn it on.
What i mean about this is after i have turned it on the first time (after i put the power plug in the back) and i turn it off i cant turn it back on without taking the power plug out of it first...
anyone know what could be causing this?
Try to play with values of resistor in J leg of pic 12c508.
If remove the J from ps2 board the console work fine ????
And report If without wire H work on DVD/r
I have find this :
If dont solder the H load only cdr.
With soldering the H loads ALL media .
Confirm please that .
The only thing I noticed with an V9 PAL Mobo was that I needed to solder "H" to boot DVD-R discs.
your resistor value on the pic fix is too low, try 2.5k for pvr lasers and 3.0k for khm lasers, that will do the trick.
yea i now, your modbo 1.1 is disable, is a bug for this chips.