i dont seem to find the v5 (SCPH 30004r right?) and v3 (SCPH 30004?) messiah installation guides on this site, while the v4 guide looked pretty nice. Could u redirect me to a good place for installation guides?
I have a 30004 ps2 which doesnt work. I tried to replace the laser of the 30004 into 30004r machine but it didnt fit. why i did this? because my laser is (i think) a little damaged. Anyway i want to fix my 30004 ps2 so i need links, manuals or advice to find out what's wrong. It would be nice if u could redirect me to a good place.
Last time i posted a question here. I got reply from charlie_ps2 who told me to check wire s (this is about v5 ps2 with messiah). But where is wire s? is it the Scex wire?
The "S" point isn't used what so ever, either on the Messiah chip itself, nor is there an "S" point on the PS2.
If you look at the Messiah chip, you can see that the "S" point is missed. Have a look at the attached pic.
Look on the right of the chip and you can see pads running down that side. From the top most pad, its identified as "I". Next one is "3.3V". Next one is not used. Next is "Gnd". Next is M, then N, O, P, Q, R, next one would be "S" but its not used. Next is T, then U, V and the last is W. So you can see from the picture that not all points on the Messiah chip are ever used. All the pads on the left of the pic, only two pads are used. One for the reset and the other for the SCEX.
I hope the above clarifies things.
Relayer :D :D :D :D