PS2 won't eject anymore

[SupraNoob]

I installed a magic 3.1 in a V3 PS2. I had it working last night playing backups, but after it refused to eject... Any ideas on what the problem could be?

[Egyptian Mafia]

try the eject and the reset wire and the ribbon. I had a similar problem with the reset and i found out that the rst wire was not soldered properly

[villasg]

More info like ( eject light , black screen , boot games ?? )

[SupraNoob]

hmmm... when i hit the reset button it flashes on and off like it should, but doesn't eject, if u hit it again after that it just flashes once

i could get it to boot games when i manually put games in there (by taking it apart) but now it won't do that anymore either

otherwise if you turn it, on it boots to the browser menu normally.

[EnTiTy]

dead ba chip

[SupraNoob]

What is that caused by Entity? Is it fixable/replaceable?

[EnTiTy]

mainly a bad install on the controller wire's the ba control's focusand tracking for the laser diode and sled movement cd tray, it can be replaced but it's not for the novice to take on search the forum you will find loads of information reguarding the ba going down.
EnTiTy

[appleskin]

the mod-chip was not fully support the v3 system
remove the mod-chip and clean all the contact point
the system will go back to normal
after the system go back to normal,
redo a new mod-chip, but never use magic 3.1 on v3
system, try the latin mod-chip, it work perfect on V3.
good luck.

[eric540]

Originally posted by appleskin
the mod-chip was not fully support the v3 system
remove the mod-chip and clean all the contact point
the system will go back to normal
after the system go back to normal,
redo a new mod-chip, but never use magic 3.1 on v3
system, try the latin mod-chip, it work perfect on V3.
good luck.

please do your homework before you say something like "mod-chip not fully support the v3 system"

[oliveshagger]

Hi, Ent

Wouldn't a dead BA give black screen?!!?