-
ps2 has died
Can anybody help
power ribbon to my laser come off & shorted blowing ps11.
Replaced ps11 but now just got the old black screen.
Press the red reset, goes to green & back to red after 3sec, spindle does not spin, no laser & no eject.
Is there anything I can do, change chips test chips etc
please help
cheers chaps
-
You should verify all the other PS2 fuses on your board to be sure none of them have blown up like the ps11
-
Yes forgot to mention I checked all 15 of them, just ps11 gone,
also after replacing ps11 the BA58 chip did get hot which is good yes! But not anymore its stone cold is there a test for the BA 58 & BA66chips
thanks
-
Alan could you tell me how to check the fuses please.
Thanks
-
To check a fuse just measure for continuity. 0ohm is good. Infinite ohms is a blown fuse.
Nm