The above video goes away if you are a member and logged in, so log in now!
PS2 CDR don`t boot on Magic 3,6!!Please help!!!
PS2 CDR don`t boot on Magic 3,6!!Please help!!! –
Iam Thomas, and iam from upper Austria, so my english is not very well,
but please help me. I have a PS2 30004 R V/V6 console, and i have a Magic 3,6 Chip
in it. First everything works well with all Games (PS1/PS2 Original and Copied)
The next day I tried to boot up a PS1 Backup, and since this, the PS2 CDR`s dont
boot even more!! All things are working, only the PS2 CDR`s not.
But the games are ok, because first i have A USB Ney Key with Action Replay V2!
What can be the problem?? Coult it be the cables, or is it the laser??
How can I adjust the laser?? Can I use a Laser Adjust CD, that cleans it, or must I
open The PS2?? Please write back!!!!! Please!!!
If the magic 3.6 have connector to bios chip then take it off and solder the wires direct to chip
I have the same problem with magic 3.5 and when I solder the wires to bios ps 2 work fine.
For help see instalation foto of magic 3
But you must very carefull when you solder the wires
Thank you for reply to my question!
Today I tried the PS2 again for a long time, and I saw,
when the PS2 has no power for a few hours, the PS2 boots again
the PS2 CDR`s! But when I
play a game, about 15 - 30 minutes, and I want then to play a
other game, it doesn`t boot again!
Only the PS1 Originals, Backups and PS2 Originals!
Could it be, that the Magic 3,6 runs hot in 15 min or so???
Did you put the Clip sticker on the Clip, the sticker will press clip to fit the bios, and you also have to use mini tester to test clip connection well or not, I have Magic 3.6 and installed for 3 months, it works perfectly.
I have exactly the same problem
When I have the chip clip on bios my ps2 boot backup games after some minutes if I close main power supply
but when I solder the wires work perfect also I think that is good idea to use the sticker tape and clean contacts of clip with spray for electronic contacts ( the blue philips is ok ) without oil if and after using the sticker and spray didnt work then solder it.