The above video goes away if you are a member and logged in, so log in now!
problem with video after trying to install magic 3.1
problem with video after trying to install magic 3.1 –
i installed a magic 3.1 on a v7 and it didnt work so i took it out. when i put everything back together the video was all screwed up. i tried wiggeling all the wires but nothing helps it. i think i screwed up when i tried installing the magic. any sugestions please.
There's a troubleshooting guide in the FAQ section. The Messiah 2 and Magic 2 TSGs are relevant to Magic 3.1, more or less.
i looked in the FAQ and didnt find any help. i gett he picture but it swirls. my mod chip is taken out out and everything looks good on the board.
Last edited by blewbuss; 02-03-2003 at 06:21 PM.
how does the video show now?
it goes from right to left, from bottom to top in kinda of a swirl.
use some desoldering wick and go over all the bios and other pins to make sure all the solder is off and nothing bridged! then check all cable connections....if anything looks beat up replace it..
if that don't work....i dunno!