The above video goes away if you are a member and logged in, so log in now!
Problem In V10 Pal The Spindle Doesn't Spinning
Problem In V10 Pal The Spindle Doesn't Spinning –
I made the romeo mod in a V10 pal machine i tested the machine before chipping and all ok.After that i started to put the MX4 chip when i finished and i tried to programming the MX4 but the disc doesn't spin.The laser trying to focus but the eye goes higher and touching the cd/dvd.All fuses ok.Where can be the probem?
Your first mistake was trying to adjust the laser. You should've taken the romeo mod and put it on a 7.5 spot to see if that would work. Maybe the la chip was not getting enough power to power your ps2. Try your best to put the laser back to normal condition. A laser within a v10 is probably new and zero adjustment should be made until couple years later.
No i ihaven't tried to adjust the laser The laser is in normal condition.I just made the romeo mod and put the MX4 in.When i tried to programming the MX4 i saw that the laser trying to focus but the disc doesn't spin.All fuses ok.
Check ps13 again
1. check ps13.
2. check the flat wire from motor
3. check for bridges in cd/dvd controler
4. check careffuly if yoy have cut any track down of romeo cutting area.
1. ps13 ok.
2. flat wire from motor ok.I put the laser on another board and work.
3. no bridges i removed the chip and clean.
4. no cut because i tried the console after romeo mod before put the chip and worked fine.
I compare the fault V10 board with a good V10 board and the only thing i found is that a pin from LB is grounded,i lift the pin from the board and ok.Thats mean that the LB is ok and the board is somewhere grounded but the problem is where?I double cheched for bridges but nothing.
Are you check ps7? This ps in front of 7808 and I never see LB blown; be careful before you are change LB.Please re check LA and romeo mod.
Sorry for my english.