The above video goes away if you are a member and logged in, so log in now!
Ok I just got Apple for V1 30001 NTSC and no diagrams match!!!
Ok I just got Apple for V1 30001 NTSC and no diagrams match!!! –
I have gone to multiple sites that have 4 different diagrams, and they all don't match. The point 9 and 1,5,7,8 or something show areas that don't even exist on my board. Anyone else with similar problem here?
Do you have the 010 BIOS? If so this may be the problem.
I have the 020 BIOS I think it says D110 020 not D110 010. Anyhow, these diagrams are different than the ones I got on the other site from where I purchased. THANKS! I just have to figure out about the capacitor and the cut track from the NEO 4.1.
Again I will post this universal guide for the ROM/CD-DVD Controller. If you cannot make any sense of it You are better off sending your PS2 to someone with experance.
Thanks, I found the right diagram. I just hope the PS2 still works after soldering this thing in. I had to drill out my posts to separate the boards. It would not desolder. However I think all I have to do is have some solder connecting the two boards once put back together. Regards!
u don't really need to desolder though
Well no go, I get only awful clicking! When I took out the Apple, now all I have is a blank screen!