The above video goes away if you are a member and logged in, so log in now!
No startup screen with chip enabled
No startup screen with chip enabled –
v7 magic v
Problem: no disc in tray, hold reset for 5 sec. to disable chip startup screen (blue cubes ) appears then goes to browser, all normal. Go back to stand-by. Tap reset to enable chip, black screen. no startup screen.
Would anyone know what the problem could be?
P.S. (If I muck around a bit tapping reset, screen may come on. If it does it plays backup's fine)
Sounds like ground bounce. The 'R' wire should be ran away from the other wires.
I have run the R wire away from the others (have had that trouble before). Do you think that the M,N,O,P wires could have something to do with it? If so I will re-solder them but if you think not then I'll leave them alone. Thanks
You might have success with ground wrapping the 'R' wire and make sure you use a short ground wire 22-24 GA.
Thanks spedmetal , A bit of an update. If I disable chip and play an original and let the console warm up then go back to stand-by, re-boot with tap, works every time. Let it cool down again and problem back. ???