Next move after soldering Matrix Infinity on ps2?

[digitron]

Hi there guys.I need to ask you something because I don't know if my chip
is defective or if I am doing something wrong.After you have soldered the
chip onto the ps2 and you close the cover should it play the backups
immediatelly or should you flash it with the bios first? Because when I insert
backups it will not recognise them.I read that the right process for flashing is
to turn ps2 off and then hold the reset button until the blue light goes on
having the bios cd in the cd tray.But if the ps2 cannot read backups how is
it supposed to read the cd with the bios? I already installed it on 2 machines
and I have the same results.The wiring is correct for sure.

thanx!

[devilboy1488]

it WILL read the bios cd

[Parisno]

- Insert the burned CD into the PS2 and press reset.
The CD should boot authomatically and you will be presented with the Upgrade sreen.
- Follow instructions on screen to upgrade Infinity.

- NOTE : You can always recover from a bad flash by hoding the reset button until
==== the blue eject light turns on. This will let you boot the upgrade disc
to reflash your Infinity.

Always works for me!

[digitron]

Ok thanx.So I guess it's obligatory to flash the bios after the soldering.
Because I thought that I just needed to solder and the chip had a bios
from it's own just not the last one.

thanx fellas!

[105854804]

but what about the slim ps2? there is no blue eject light.
and where can i get the bios? can somebody upload it?

[loy]

how about checking there site. IT's stil hold the reset button but u have to hold it for some time