More Duo 3 Install help
Okay I got the chip in finally, and it did not come with an installation guide like I thought, just the crappy diagram I can get from a number of websites, well I was sent two different types of wires, mostly ones that are extremely thin, like very small fraction of an inch, and then a thicker wire, but less of this wire, the thicker one seems to be more normal girth....so what is the difference between these two? Does anyone have any idea or should I just use the same type wire for all my soldering...also with the super thin one I'll probably just buy a better gauge
The thicker one are normally used on GND and 3.3 v
And the thinner ones are for all the other points.
should i get a thicker one for the other points or stay with what was sent to me?
Originally Posted by jetcat
No you could use the thinner one on all points.And the thicker one power and GND