The above video goes away if you are a member and logged in, so log in now!
Mod-Chip 3.6 –
OK i mod-chiped my PS2 3001 R and got the chip from Mod-chip.com ,and was wondering it show's the diagram of the install of the chip and it shows the BGA Board only being hooked up saying Version 5, So does this mean i don't need to use it on Version 6? It is the Magic 3.6 http://www.mod-chip.com/images/m35diav5.jpg
You must use it on booth V5 & V6. If you dont want to use it you will have to conect the wires one by one on specific points B,C,D,G,H,I.
This is magic 3.11 with clip kit.
Magic 3.6 –
ok thanks then does that mean that the Place were it goes is the same on the V5 AS V6,cause the pictures and instruction's on there site does not tell you very much at all kind of leaves you guessing were it goes, it came with no instruction's on paper and all they give you is pic's and not even all of them at that, being a first time Mod-chip any ps2 i can use all the help i can get, do any of you have or know were better instruction are and pic's that may help Me Thanks in advance Sean.....
V5 & V6 mobo looks the same. I dont use clip kit, so I can't send you a pic. becaouse I dont have some. I will send you a pic. of magic 3.11 for V5/V6, so you can compare solder points.
Here is pic. for V5 & V6 500kb, previous was 1.5 Mb