Messiah2 NTSC fix for V5?

[Soler]

Hey guys,

I'm trying to do the PS1 colour fix but can't find any pictures on which points to connect for my NTSC v5. I followed the m2 install pdf for the install but it doesn't show the fix.

I tried the points on the attached diagram but this causes the ps2 to turn on for a few seconds and then returns to standby. I have also tried connecting from the ic leg to an alt 3.45v source but still get the same results.

If I disconnect the wire then the ps2 returns to normal.

anyone have any experience or info on the fix?

TIA

*** removed diagram as it was wrong

[EnTiTy]

that was one of my diagrams i posted on irc last night by mistake its incorrect for the v5
ntsc. this one is what you need.
tested it myself and it works fine
EnTiTy

[EnTiTy]

sorry about that l8 night last night when i did the diagram you can use the second leg in instead of the via point just connect it to the alternate 3.45v down by point a as you already know.
EnTiTy

[Soler]

EnTiTy,

New diagram works like a charm! I'm one happy camper. I used the via as the legs are too close for my skills.

Thanks again!

[EnTiTy]

your welcome m8 no problem glad to be of service.
EnTiTy

[thetieger]

entity does good everywhere! i wish my V7 came in...then i could tell ya whats goin on with that and u could help me out but its not think its lost in the mail

[EnTiTy]

when or if you do get it give me a shout m8 i would be glad to help.
EnTiTy

[thetieger]

will do

[marc21782000]

PLEASE HELP ME:

I DON'T UNDERSTAND WHERE I NEED TO CONNECT the NTSC/PAL FIX POINT

I DON' UNDERSTAND WHEN U SAY

just connect it to the alternate 3.45v down by point a as you already know

WHERE IS TIS POINT:

ON THE CHIP

OR

IN THE MOTHERBOARD

THANKS

MB

[charlie_ps2]

Originally posted by Soler
Hey guys,

I'm trying to do the PS1 colour fix but can't find any pictures on which points to connect for my NTSC v5. I followed the m2 install pdf for the install but it doesn't show the fix.

I tried the points on the attached diagram but this causes the ps2 to turn on for a few seconds and then returns to standby. I have also tried connecting from the ic leg to an alt 3.45v source but still get the same results.

If I disconnect the wire then the ps2 returns to normal.

anyone have any experience or info on the fix?

TIA

*** removed diagram as it was wrong

I was surprised that the one in the Messiah 2 diagrams for v5/v6 didn't work. It's the same as Entity's except that I've also shown it taken back to the leg for thosw eho don't like soldering to Vias.