Messiah 2 Installation
Ok I am upgrading my v5 ntsc ps2 with one (had a magic 2). My question is will I be fine using 32 awg wire on all the points except the ground and 3.3v which I used ? Can I leave the 32 awg wire I used for the same point as clk on my magic 2 install or do I need to use a thicker wire? I think that is what I used on my magic 2 install and will just leave them in. On the ntsc color fix, how do I do that point? It shows 2 point there, a little pad and then the copper circle which is connected to it and it says to run it to the 3.3v point. I assume I pick one of the 2 points it shows and then solder the wire to one and then solder the other end to the same point as 3.3v? Thanks.
it fine u can use the same wires u used for your magic 2 it'll be ok
for the color fix u take the color fixed point to 3.3v if yoru board is ntsc and color fixed point for pall board bring color pal point to ground