matrix infinity homebrew problem

[gsd2000]

I have a v9 ps2 (50003) and i have just soldered my new matrix infinity homebrew in. Before i installed the chip i could play games and dvds fine but now i cant play anything, the console just freezes and i cant do anything. It does this once its at the brower menu and trying to play the disc. I haven't yet checked my soldering, but is there any specific points that could cause this?

[gsd2000]

i checked the wires and found a few loose ones which i soldered again. The console now boots up fine and plays ps1 and ps2 discs but will not regonise the matrix disc i created. Is there any way of checking that the chip works or is there another way to create the matrix disc?

[villasg]

Make the flash by hoding the reset button until the blue eject light turns on.
This will let you boot the upgrade disc to reflash your Infinity.

[gsd2000]

i just tried it and it wont work i can force boot it but it then comes up with illegal disc inserted. is there anything else that could help?

[villasg]

Plz make a test .
Start the machine with START have pressd in the joypad.
Show in tv the DISABLED logo ????
If no then have problem in this points :
bios ( MNOPWRQTUV )
+3v
GND
RESET
Y
SCEX (S)

[gsd2000]

just tried it and it did NOT get a disabled logo, i have checked points MNOP as they were bridged so i will check it all again. Would it be wise to remove the chip altogether and install it again?

thanks for your help

[gsd2000]

i have used 0,25mm kynar wire, i don't know what guage that is but is that ok to use on all the points or do i require a different guage wire for the ground and power? I have decided to remove my mod and reinstall it as i have a few bad connections but the wires are also in a mess.

thanks for the help