Magic v7 Installation gone bad I need some advice
OK everything was going fine. All of the wires were soldered and looking good. Then it all happened. The 3.3v power would not solder. So I scraped and scraped and soldered and resoldered and then I continued to do this for about an hour and the solder would just not hold.
I then took about a 6 hour break and went back to work on it. I cleaned up the area, scraped and soldered and continued back and forth for about an hour (The solder would not hold). Then it happened. The little capacitor came off.
Is my world over???? Do I call it quits???? Any good electronic advice out there??? God I've invested so much in this that it kills me to even type this thread but I need some advice.
Oh by the way. I can't find the little 3.3v capacitor.
Please tell me some advice.