Magic 3.1 points on V3 PAL

[TDM]

Hi,

I'm going to install a M3.1 on a V3 pal ps2, I saw the official diagram on it's full of via
So is there any others points for the bios area os some easier alternate points ?

Post pictures if you can

Thanks in advance bye

[charlie_ps2]

There are no vias - do you mean pads? They're OK.

http://www.china-magic.com/magic3/di...GIC_III_V3.jpg

[TDM]

The points M to V are difficult because they are located on little "hole" (maybe i have not used the good word) which need to be cleaned for the solder to "stick"

So that's why I asked for some alternate points for that part (if existing...)

Thx anyway and sorry for my lack a technical vocabulary

[betablockers]

TDM the board conection points are mainly VIAs, and the V3 conection points are on the whole a bad choice, with the +5 being the worst. I haven't a V3 here to trace the point again but the EPROM points M-V, I trace back to the EEPROM and connect there.