The above video goes away if you are a member and logged in, so log in now!
Magic 2 v4 - Test Results
Magic 2 v4 - Test Results –
SCPH30001R with a v4 board inside
Serial starts with U0 Date Code 1C NOGAP ROM
Test Chip: Magic 2 v4
Results:First let me say that this console was dirty as hell and the laser head had to be cleaned. Original DVD would Not work from the get go but I did the test anyway. Originals booted OK BUT CDR and DVDR backups WOULD NOT BOOT. The ps2 backups would start to load then BLACK SCREEN (Never finished).
Side note: I did piggy back on a (R) chip to see if it would work but let me tell your first this chip is in question. Some guy botched an install brought it in for repair got his PS2 running again reinstalled his chip and It did not work. I piggy backed on another fresh chip I had and it worked. So this (R) chip is iffy that I used for testing.
Results: All backups goto red screen of death.
Below is a PIC of the v4 install
err, thats like the exact system I have so thanks for the report. I heard I was supposed to get a Magic2 "R" chip for this but you said that you used the Test Chip: Magic 2 v4. so which is it ? I hope I can use the "R" chip cuz I just ordered one like 5 minutes ago which install diagrams did you use ? those points dont look even close to the ones on the china-magic site.
I would cancel the order if I were you, ZINJ Because I have tested magic 2 from Lik-sang with my 30001r, v4r, nogap datacode:1c and the result is "red screen of death"
also has any one had any success?
are you sure about this ?? everything I read on these forums excluding this thread has said I should get the "R" model Magic2. even the china-magic diagrams are installing the r on my board
any other opinions? LOD? charlie? niceguys?
you should have the 'r' version magic 2 for the v4 1c.
gaz da man what about if i have a v4 nogap bios030 can i use the messiah(the pal one)
and my motherboard is Gh010, does the Gh010 means it's a version 4 cuz i swapped the board and i don't remember.
I guess you can try it and post your result. because I haven seen any result yet and for me I gave up. Install and reinstall couple of time but nothing came out except the "red screeN"
which install diagrams did you use, icebot?
I use the diagram from china-magic v4 but you should also check xxx.modchipforums.xxx because it might be the chip from lik-sang.
Icebot does your board say GH010, and do you have v4 1a?
if yes send it to LOD it works, many people told me it worked the only reason i'm holding right now i'm not sure if my board is a v4 or not.
By Da Brass in forum PS2 Modchips
Last Post: 10-28-2004, 02:18 AM
By meyousikmann in forum PS2 Modchips
Last Post: 01-04-2003, 12:48 PM
By Astina in forum PS2 Modchips
Last Post: 09-29-2002, 12:19 AM
By charlie_ps2 in forum PS2 Modchips
Last Post: 09-15-2002, 06:45 PM
By CN-Twat in forum PS2 Modchips
Last Post: 08-18-2002, 12:00 AM