Magic 2 V3 Newbie help
Magic 2 V3 Help
scph-3001 no R
with the electrical warning on back
and 10 screws..., its a V3
And i purchased a Magic chip 2 V3 (red) and wondered if sumone can walk me through it step by step...im new to this....but am having a proffesional solder it, like what is the 3.3V,GRND,Reset, and 5V, and i have colored wires, and i c the letters on the diagrams, but are the colors supposed to go to certain letters or does it not matter............please sum one hold my hand and walk me through this.... i seen the modchip.ca diagrams....more detail is needed! please help
:confused: :confused: :confused:
Try the Lik-Sang/china-messiah diagrams, in addition ot the modchip.ca ones.
I still have not fully installed mine, due to the difficulty of installing on the pins of the DVD controller, and lack of anything finer than a 1mm soldering iron tip.
Nobody has proposed alternates for those pins yet, though I'm SURE they must exist. I'd even be willing to solder to the underside (though the 'S' wire supposedly is the same as Pin 2 of the Neo2, which is a top side pin, accoring to the Modchip.ca diagrams)
The modchip.ca diagrams are VERY confusing, since they overlaid the place where you solder in the BIOS points (the copper contacts at the top).
I don't really have a high degree of confidence in any of it.
Also check mine and other posts here and here