The above video goes away if you are a member and logged in, so log in now!
Macro-off...for the interested.
Macro-off...for the interested. –
Here is the old Neo Macro off code released last year sometime.
This code was one of two release..This one has performed well for me in a V3 ever since it was posted.
Chip is a 12C508/509(a) . 4 Wires. Low salt.
Suitable for V1-V5..dunno about V6/7
Last edited by ralcool; 11-26-2002 at 10:28 AM.
diagram for v4 –
v1-3 again –
sorry about other post.....
Works perfectly in v0 to v6. It should work on v7, but no one, nobody, have found the new soldering points to put this PIC into v7.
And I need to know just 2 points on v7. The other 2 points are equal for all consoles (v0~v7).
The points are 5 and 6. 1 and 8 are always the same.
Last edited by Gradius; 11-26-2002 at 11:02 AM.
tis true.. the point are the same..the orientation of some componts scare peeps if their boards arn't identical..hence all the varient pics. :-) as released. cheers neo.
for the world again.
and a handy pic burner for 12C5?? and 16C84's. icprog1.04 compatible
Last edited by ralcool; 11-26-2002 at 11:44 AM.
The NEW D/A video IC on v7 is
OLD IC was:
S044728APB on v0~v3, SC44728BPB on v4 and SC44728CPB on v5/6
2000 and 2001 SCEI
Pins 5 & 6 (from macromod) is connected on pins 29 & 30 on OLD IC.
Last edited by Gradius; 11-26-2002 at 12:08 PM.
I just need the datasheet for these ICs to found out the new points on v7 !
Where can I get that ?