The above video goes away if you are a member and logged in, so log in now!
A little help please taking my case apart...
A little help please taking my case apart... –
I have just taken my PAL v7 ps2 apart to install a matrix infinity modchip and I cant get the top of the board to seperate from the heatshield to do the I point. from what I can tell this is the only point that needs connected to the top of the board as all the other points are on the bottom along with the modchip.
Are they attached in any way ? I have looked for any remaining screws but cant see any, I have given it a little force but dont want to snap the board.
just to note: everything else has been removed already ie. the drive tray, the psu the bottom heatshield etc..
pull harder! i asked the same question a while back wit a v9. i held the shield off the board for about 30 seconds and the thing popped right off. theres a suction or some glue on the processors so it takes a lil force to take off
the first time you do it - its a bit scary. I remember thinking does this thing really come off or am i going to snap to board in half
Slide your hand under the other side of the heatsink and work your way towards it underneath. It should come off easily with that technique.
cheers, the damn thing just flew across the desk