La6508 replaced, no disc spin however

[Protosstic]

Well looky here, i am back with another part of my story.

How it all started

Anyways follks, so I got oen of homersimpson's la6508's installed, and oh my god, it ejects! As well, the laser's beam does work. But I got one problem. The disc drive is not spinning the discs. I only got the one v9 drive, but have v7 drives, will i be able to try them in the system. Any ideas what could be the problem now, like stated before I replaced the one fuse (PS8), and can't seem to find any other bad ones anywhere. Anybody happen to know which pins on the LA serve what purpose? Thanks again!

[yahooadam]

No particular offence but in that pic

Ure soldering doesnt look amazing

You should leave the iron on it for about 4-8 secs for the solder to 'Flow' and it will give it a shiny look

This will make a better electrical contact then what you have done
Also if you have a magnifier you should have a look at your soldering, or use a multimeter to make sure that it is not shorted on any solder you made, or and close by you may have got with the iron

[Protosstic]

Hehe. Well I will be pleased to announce that isn't my soldering first off, it was a pic of how to install the other la chip. Secondly this is the la chip I have now installed, and the soldering is great

http://www.worldmodchips.com/images/ps2/la.jpg

So what else should i be looking for to see if I can get this mobo fixed? Thanks!

[letsmod]

check the fuses especially the one near the LB chip as this control's motor spin.