The above video goes away if you are a member and logged in, so log in now!
Black Screen –
I try solder a modchip and i burn point 2 in the next picture you can see what point
Now i have no video and no continuity in that ponit can i fix?? that??
Sorry my bad english
Last edited by pilsentico; 01-02-2005 at 08:25 PM.
that pad is part of a trace , you will need to make a jumper wire to complete the circut now if there is enough of the trace left . you most likely are using an iron that is to many watts , wire that is to thick , or pulling on shit to hard .
You need a fibreglass pen to scratch the trace to reveal its copper trace then you can make a jumper wire.
thanks i will give it a try but at least have a fix for and don't have to buy a new MB
and wgere do i have to solder to make a jumper wire????
That because there is no rest of the point 2 like all others
and if i install a mod that don't need that point even if there is no continuity it will work???
Most likely not, cause those points are connected for a reason...
If you just burnt off a pad but everything else is in tact, in theory your PS2 should work beacuse the point is not going anywhere and is acting as an open when the PS2 is on. I am not totally sure that things don't pass through the pad though which could cause a problem. you should be able to trace to a test point and run a 30 AWG wire over the pad to the next test point, kinda like with the xbox mod, so the pad is completly avoided.