The above video goes away if you are a member and logged in, so log in now!
HELP! MAtrix Infinity on v7 not booting backups
HELP! MAtrix Infinity on v7 not booting backups –
i have just installed a MAtrix Inifinity Homebrew (blue Dot) into a v7 ps2,
installation went fine, i can disable the mod by pressing start at bootup, i can can get to the mem card screen by holding triangle.
but it wont boot any ps2/ps1 backups, it loads then goes straight to red screen of death.
it will play region0 dvdr
my matrix position is like this one: http://d-vices.com/install/mxi-v7-ff.jpg (this is not my install)
ive rechecked the wires over and over again now im confused.
ive used the gold edging for ground.
do the other wires have to be parallel to each other or can they be crossed?
any tips advice on this one?
I've not installed mine yet but from what i've read the Blue Dots are blank and need to be flashed with the latest firmware to boot backups.
Read the "Matrix Infinity Blue Dot" thread
this is true, need to upgrade the flash
when ii could disable the mod, it would say v1.21 (ithink)
then i relised that i had missed oit point 'B' completely! (sp?)
soldered that on and all was fine, updated to firmware 1.38 with no problems
cheer for the help guys!