H2o Pro V14 Rsod

[zorro69]

Hi,

Just wondering if anyone had any luck with a H20 Pro with the gold dot on a V14 board?
The board I have is a GH-041-03, and I was told to put it in the same as a GH-037-01.

Anyways it plays originals but not any burnt copies. It will play a DVD-R movie. I've tested the burnt copies on another ps2 and they do work.

I've been reading on this forum about the H20+ chip. I tried the 5 volts to "H" and removing "z" and the 1K resistor between the GND and 5 Volts.
I tried the the short heavier wire for ground and 5 volts.

I've tested with my multimeter from I G B A pads to the controller Pins 79,81,86,89

I haven't tried the heavier wire to "A" yet. Not sure what "A" does?

The H2o Pro and the Matrix are so close. I notice the Matrix has a "Y" and on the H2O Pro has the pad but its not labeled?

Any ideas.....

[dungbeetle46]

when you play the dvd, does it reboot a second time before it plays it, if not then the chip is not even working