The above video goes away if you are a member and logged in, so log in now!
Gameshark 2 & M2 V7 problems
Gameshark 2 & M2 V7 problems –
I installed my V7 M2 Chip into my PS2 (39001).
PS2 CD & DVD backups/originals work fine.
I tried using my original gameshark 2 today. It loads, I set the checkmarks for the codes (M is checked). When I remove the disc when told to, and I press "X", it says, please wait... updating... and it sits there forever.
Has anyone else had this problem?
Would appreciate any help.
I have run into several problems with this (Z) point on a couple of PS2's when connected Backups would not load? Disconnected Backups would load. Never tried to load a game with codes though on the PS2's were this connection did not cause a problem.
I forgot to solder the Z connection. I can't believe I overlooked that.
I remember looking at the M2 board seeing the solder point. I went back to my copy of board solder points and sure enough I didn't check off the Z point. I soldered it and it worked perfectly.
Now if I can only get the PS1 games working properly
By cipcipstore in forum PS2 Modchips
Last Post: 02-10-2003, 03:06 PM
By usafa92 in forum PS2 Modchips
Last Post: 01-04-2003, 04:00 PM
By Super_Chunk in forum PS2 Modchips
Last Post: 12-20-2002, 05:12 PM
By vpforlyfe in forum PS2 Modchips
Last Post: 12-03-2002, 05:46 PM