A few Questions about installing DMS3 V2
If this is the wrong forum im vary sorry. This is my first post so im not Sure what category to ask these questions in. It sounded the most appropriate in the description of this forum to post it in here.
Is the temperature on my soldering iron really that important? I can set it to either 350 deg or 700 deg No in-between. I have been practicing on both, and 350 deg dose not seem to melt the solder vary well. Is it ok to use it at 700 deg?
I believe the tip I have on it is a 40wat. I saw this in the instructions for another chip "Do not go above an 18 watt soldering iron or damage may result? The lowest watt tip I can find is a 20 watt. Or is the 40 watt ok since I can kind of adjust the temperature I wouldn?t think this would matter what do you guys think?
OK last question. I have seen people use what looks like "Hot Glue" To organize there wires. They glue it right to the board. Is this any special glue or just plane ole hot glue?
I really appreciate any one taking the time to read this and helping me out.