The above video goes away if you are a member and logged in, so log in now!
DVD DRIVE WONT SPIN UP now that my green dot is installed
DVD DRIVE WONT SPIN UP now that my green dot is installed –
Matrix infinity V7 ps2 DVD DRIVE WONT SPIN
I installed a matrix infinity green dot in a v7-8 ps2 yesterday...when i turn it on, the DVD drive starts to spin, then stops abruptly. I see the matrix logo when I turn the unit on....I can navigate in the OS just fine, too, but whenever I put a cd or dvd in, it spins up for about .5 seconds then stops.
I should also mention that only the ground was done in 23 awg wire...the 3.3v connection and all the others were done in 30 awg wire. Is that a problem?
also, are the solder points different in a v7 and a v8, because the official infinitymod.com installation manual grouped 7 and 8 together.
V7's and 8's are essentially the same.
Yes the wires used should be fine as long as the 3.3v one is not to long and is kept close to the mainboard.
If it is a clone or containing the worng firmware then this might happen. Or if you have selected the wrong boot method.
Try disabling it and running an original.