The above video goes away if you are a member and logged in, so log in now!
Duo3 - v14 - GH-040-52 - No 'Z' point on install diagram
Duo3 - v14 - GH-040-52 - No 'Z' point on install diagram –
I just popped open a 75001 w/ a GH-040-52 mobo. The install diagram on the official website is here: hxxp://www.duomodchip.com/english/install/duo3/duo3_v14_v16_temp.jpg
But unfortunately there isn't a 'Z' connection. Just wondering if anyone knew exactly where this should be - or should the Z connection be left off?
I think I'm going to try the point in the picture below - which is from a v12. It looks close... But if anyone has a suggestion - I'm all ears!
Perfect! Thanks cleo... that should work. If it doesn't, I'll post back.
Got it installed earlier today after I posted last, and it worked like a charm. I had figured that was it - but I thought I should double-check. Thanks again.