Duo2se V10 Help Needed
Ok doing a v10 with Dou2se
Install fine , romeo mod done to 8v full working.
Chip wont seem to power on (dvds movies and originals work first time , hold power button when turning it on turns it off) (for disable mode)
All points double checked , not my first install. What could it be..
Otherwise i have a messiah4.2 i got from a other job , but didnt install as his was a v7 (i know its a clone. i DONT REALLY want to use it)
You mean you connected the LA to 5v right? 8v would cook that thing.
Do you get an RSOD with backups?
i understood that the LA chip is 12volts normal
so i used 8vs ( i found a thread here about it. might change it too 5 tomorrow)
Yes i get a RSOD with backups
But i dont think the chips getting power , but im using the right power points , tiny ground. Might try the alt power points i found tonight..
If you're getting RSODs with backups, better check the CD/DVD controller points (usually A,B, I, and a few more for the V9/V10s).
All points checked again and tiny ground wire and differnent vlt+ point as seen in someone elses duo2se v10 pal install (alot shorter)
Still working just like the chip aint install , EG. (Hold power button until clouds turns off ps2)
I think i have a broken chip , would be my first. Unless anyone else can suggest something..
I suppose it could be a bad chip, but somewhat unlikely.
I've ran into two different v10s that didn't like the Duo2SE chips. I spent a TON of time troubleshooting the installs, only to give up and install a Magic5KX+ chip - which worked perfectly in both machines.
Although they claim that the Duo2SE works with the v10s, after a little bit of reading I found that alot of people have had the same problem. Save yourself the time, and try a different modchip.