v3 tray not closing problem
This happned twice to me now, after installing duo in a v3 (gh-006 board), the tray comes out but it wont go back in. The eject light just flickers once but doesnt go back. Without the chip same thing happens now :(
Anyone got any ideas? theres no shorts, bridges etc and i've taken great care with the 2 points on the contoller chip....
Some v3 i've modded in the same way with duo worked perfectly.
I took the chip out now, cleaned everything up, tray opens and wont close. Slight push and it will close (wasnt doing this before). I read some posts with people having the same problem and in many cases their problem was the connection where the z wire goes on the resitor network chip. Mine seems to be soldered good. When i measure each point on that resistor network chip i get 10k across it, except for that z point i get 2.5K. This is with the ps2 off ofcourse. The point goes to the pad on the controller chip so theres no way of knowing if this is the resistance i am supposed to be getting.
Any ideas what else i can try?