DMS3V9 on V10 - SOUND PROB

[calmatador]

Hello all,

I have read many posts regarding the sound issue(s) and the interference with the CLK wire. I have read the following solutions:
-a thicker wire (24 gauge, instead of 30 gauge)
- wrapping the 30 gauge CLK wire with a thicker (22 gauge) grounded wire.

I was wondering if anyone can post the spefics on how to EXACTLY solve the problem or literal fixes.

The other main question I have is: Does anyone know where there is an ALT CLK Point aside from the one by the largest chip?

I have placed my DMS3 on the open space by the A/V connector and the USB ports. My ground wire is short and the chip works fine. After about a few mins of gameplay, the sound will either shut off, only partial sounds will be heard, or i will get a long continious beep.

Please help, and I appreciate any advice.
-Cal
nobodyimportant@hotmail.com

[kima]

Place the DMS3 so the CLK point at the chip and PCB is just aside. Then you'll have a CLK-wire that is 5 mm long, and no more sound prob.

Kim A