The above video goes away if you are a member and logged in, so log in now!
Dms3 V2 Installation Help
Dms3 V2 Installation Help –
I have installed DMS3 V2 on a PS2 V4 pal. Every time when I switch on the console it doesn?t display anything. If I switch on and off for few times it works. Then all the functions work fine. Anybody experienced this type of problem? How do I fix this?
Please help me.
Possibly a cold solder joint, or a peice very small peice of sodler bridging connections every so often.. check all of your connections very closely.
I have checked all the wires and solder points also and I have re-soldered them. They all seem to be ok.
Wire D, E can cause this problem? I have used high density SCSI cable. It is very thin ribbon cable. The reason have used this cable is I couldn?t get any fine wire in UAE.
Raju, fine wire was my problem too. Am in the process of installing dms3 at the moment. Had same problem as you, traced it to the following. M needs to lay flat against MB, D and E also need to be flat across MB, cannot be in the air. ALSO X and O.
This should help.
This is of course if you didnt cross any legs on the bios chip.