The above video goes away if you are a member and logged in, so log in now!
DMS3 installation tip –
I've read A LOT of post about the installation of dms3, i think that there's a common point in all the successfully installations, and i want to find it.
A guy from divineo told me that the point X,O, D and E should not be crossed by any wire, so this question goes to the people with working installations of dms3
Did you install the chip with parallel wires ?
also, if you can post a picture of it, it will be great.
Last edited by oddie; 04-09-2003 at 03:13 PM.
DMS 3 V2 –
Fitted to a GH O18 Board Pal
works just great
did u stretch the pic?
it looks kinda warped hahaha
no just the way it took in the scanner