DMS3 Plus has started shipping. Users will have to upgrade the firmware to 2.3B4 before being able to use the config mode.
Flash 2.3B4 will be online tomorrow.
A note on a few operational changes to DMS3 Plus.
1) After flash upgrade you will have to reset the machine from standby before the machine will operate as usual.
2) After changing settings in conifg mode please go to standby and then restart the console, before playing software.
3) In order to boot from the back up bank flash, you are now required to press Reset 4 times in succession.
We are currently preparing new diagrams especially for DMS3 Plus. In the meantime we will upload temporary diagrams tomorrow.
The clock point on the DMS3 Plus should now be connected to the RF Clock point on the console, commonly known as Y on other mods.
The V wire is only required on Japanese consoles and should not be connected on USA or PAL machines.
On the CDVD bus, the following wires are required for V9/V10:
O,P,U,W (+ V wire if console is Japanese/Asian model)
for CDVD bus V1-V7:
O,P,W (+ V Wire if console is Japanese/Asian model)
for CDVD bus V8:
All other points remain the same as DMS3 diagrams.