DMS3 black screen problem (only when chip is put on wires)
I've just done a dms3 in a v9 ps2. I used the cd/dvd chip points instead of the VIAs.
All the wires are on, and when i test it, it boots fine and plays all media.
When i start to put the wires on the chip, i get a black screen.
If i take the wires off again, everything works.
What's going wrong? Does this point to a faulty chip?
I've got as far as soldering on everything except the power wires and cd/dvd wires to the chip. If i solder them all on, will i get anything different?