Connetion between Dead BA6664FM and Duo2 Z point? –
I installed a Duo2 into this v7 and noticed after ejecting the tray wouldnt go back in. I removed the Z wire and the problem was fixed. Now though I have a new problem, a dead BA6664FM. pin 8 did bridge with ground so i assume the chip is dead. I got it replaced with a confirmed good ba6664fm but right after I turned on the console it died. All fuses are ok so now I wonder why it died a second time. The first time I had noticed a capacitor came off the board and was bridging pins 16 and 17, the cap was quickly resoldered and the ba chip replaced just to have it die again. Laser coils are fine reading at 5.8ohm and 6 ohm. Anyone with similar problems because im completely stumped.
Last edited by OttawaMods.com; 02-28-2005 at 05:48 PM.
OttawaMods.com Modchip Installation & Serivces
$90CAD for Dual Firmware Mod Xbox1
$50CAD for DuoX2 Lite Chip Installed
Check out my site for more www.OttawaMods.com