The above video goes away if you are a member and logged in, so log in now!
cc1.1 trouble –
did the romeo mod. and installed a cc1.1 in a v9. made a flash disk booted it and flashed the chip it said done so i assumed it worked. tryed a backup but no go. i stuck the flash cd again and it wouldnt boot.
chip led comes on and goes out on startup. tryed to get into recovery mode by hitting reset 3 times but i really dont know how/when.
so i unsoldered all wires to the chip and checked for resistance from wire ends to ground all show connectivity. so i stuck it back together to get the same thing.
i took it apart again and resolder all bottom connections including ha. still same thing, sometimes red screen sometimes disk read error.
it will play retail games still, when a game is loaded to menu and i hit eject it stays at the game menu and will load if i stick the disk back in.
im assuming i have the chip in right because of the led showing bios and dvdrom controller wires are right? what wires should i check? is there certain media i should try? i used imation cdr and dvd-r
Last edited by staticvoid; 04-19-2006 at 04:55 AM.
Try different media. Could be a bad chip, but usually they don't flash at all if they are.
Installer Located In Oakville, Ontario. Walk In or Ship It.
Installs & Premods Available--Email:firstname.lastname@example.org My Vendors Thread Oakville Mods
**360 Firmware Flash - $50 CDN** **Bricked Hitachi 360 Drive Reprogramming - $60 CDN**Wiikey&WiiFree In Stock
resoldered everything, now the dvdrom only spins up sometimes.
when i boot a retail disk the eject blinks a few times then light stays on for a sec then blinks a few more times then boots. backups still no go.
i damaged one of the ribbons, i repaired it, now it spins up everytime but will not play anything on dvd including retail ps2 games.
plays cdr and ps1 game backups without a problem.
im trying to figure out if i some how damaged the laser, onee of the chips , or screwed up on installing the chip.
Last edited by staticvoid; 04-20-2006 at 07:12 AM.
romeo mod was done on this machine.
coils test 4.6 and 4.5.
is there a chip i should check?
are there seperate wires on the modchip for cd and dvd?
Last edited by staticvoid; 04-20-2006 at 06:22 PM.
i replaced the laser and it would read dvds but not cds. replaced it again and everything is good.
Originally Posted by staticvoid
you lucked out