Black screen (already checked Charlie´s guide)

Hey guys,
I installed a Magic 2 in an ps2 V6 GH-015. After I put the ps2 togheter I only got a black screen. After I checked everything I saw I damaged the power/reset cable. Checked the cable, and it´s still ok. I checked Charlie´s faq guide. Everything seems ok. After I removed the chip, I still got only a black screen. I used the image of a V7 board to check the fuses. I found and checked 13 fuses (didn´t find ps14), there are all ok. I have been trying for weeks now, can find anything that could cause this problem.
Does anyone have any suggestions??? I don´t know what to try now..
Thanks..

somewhere on the bios you must have a bridge most of the time you have a bridge it causes a black screen

cheers:D :D :D

I checked the bios, cd/dvd controller. Disconnected all the wires, and checked with a multimeter. It seems ok. I don´t get it..

check all fuses

I used the image of a V7 board to check the fuses. I found and checked 13 fuses (didn´t find ps14), there are all ok.

villasg you vlaka he said he already check the fuses

the only problem i can pin point is the bios you may have a bridge from the inside of the bios behind the legs

cheers:D :D :D

ok, so can I check it with a multimeter by checking if any of the points on the bios are connected with eachother???

I checked all point on the bios with a multimeter to see if any connected with eachother.. non of them was connected directly, a few pins that are next to eachother has some ohms (800 - 1200 ohm) but that is ok?? Only if there is a direct connections its a problem (0 ohm), am I right?? Are there any other fuses/components that I check to see if they are ok??

its not the fuses trust me

then you got a reading on the mm was it in the middle of the bios
i cant remember exactly but in the middle of both site either 2nd ot 1st pin in the moddel are link att he factory this is next to the gap if you have any

does your bios have a gap there the only 2 bridges i know that are ok but apart from those 2 bridges there shouldnt be any bridges on any of the pins where you solder M.N.O.P.Q.T.U.V.R.W
to the bios

so like this the 2 last pins on the bios next to the gap are ment to be link the rest of the pins are not linked

cheers:D :D :D

Where is Charlie´s faq guide ????