The above video goes away if you are a member and logged in, so log in now!
red light on –
Hi I want to mod a V9 PS2 with CC 1.2
The problem is the red light is on.
I tested all wires for connection and all close pins for shortcuts.
I found one possible mistake in area 4 in the official wire setup.
Point N is shortcut the the pin between N and M.
Is this OK?
All other wires are looking fine.
I got it I used a needle to clean the gap and now it works.
I was afraid of cutting a wire of the board with the needle.
Was a long day
Last edited by Katagia; 06-25-2006 at 06:02 PM.