No backups run (not even firmware discs), chip flashed with v19 modified via inlink

**patch6** · 03-05-2006,01:55 PM

Backup software seems to load like normal, but after a little bit the spinning just stops outright, and in the bootmanager it keeps restarting the load sequence, and in the browser, it just gives the red screen o' death.

What could the problem be? Any particular wire solder points that could cause this problem on a GH-019?

**indoweed** · 03-12-2006,04:03 PM

Check your wiring. Likely a install error. It can be a wire came off. Check the B or A wire.

**patch6** · 03-13-2006,11:48 PM

Thanks for the reply.

I've checked the wiring thoroughly, under 10x magnification and strong light, plus the entire board for solder splashes and bridges. None of the wires are crossed or even touching.

The loading routine sounds identical to that of a stock system trying to load a backup, but other chip functions remain. It skips the Playstation 1 / 2 splash screens when loading an original, and the bootloader loads up fine, but backups don't even register to it. I even tried flashing different hacked bios versions via inlink, same effect.

User Tag List

Thread: No backups run (not even firmware discs), chip flashed with v19 modified via inlink

Tweet

LinkBack

Thread Tools

Display


	Would you like to get all the new info from PSX-Scene in your email each day? Subscribe to our Daily Digest! Want to learn more about the team keeping you up to date with the latest scene news? Read about them now! Check out our Developer bios, too!