My CC 1.0 has a TO pad marked.... but the install diagrams (v14) don't require it...
Why is that?
Thanks,
DT
PS
Thanks to an expert installer my CC got installed. I've hung up my soldering iron... for a while at least...
Printable View
My CC 1.0 has a TO pad marked.... but the install diagrams (v14) don't require it...
Why is that?
Thanks,
DT
PS
Thanks to an expert installer my CC got installed. I've hung up my soldering iron... for a while at least...
Sorry... just found the answer.
No need to wire TO for CC 1.0
That's a relief. Not sure why there is a pad then!
the CC1.0 uses the TO on V1-V8 PS2's and not on the V9-V14 thats why. However the CC1.1 uses the TO on all versions.
spedmetal Thanks for the response.
I looked back a few versions but didn't get as far back as v8!
I understand now.