Crystal Chip 1.2 Installed, No Video

CrackerStealth · 11-12-2006,04:08 PM

I just finished installing a crystal chip v 1.2 in my PSTwo with a GH-051-02 board in it. The first time I tried booting up, the PSTwo with the chip installed the LED was constantly lit. I went back and redid a couple of the BIOS wires, it looked like R and N were touching two pads. So I fixed the points and tried again. The crystal chip now shows proper procedure, the LED comes on for 1 second then goes off, I can also here disks spinning up, but I get no video and no sound.

Any ideas where I should start looking? If I remove the power to the chip, would it be like the chip was removed or do I really have to remove ALL the wires?

CrackerStealth · 11-12-2006,05:38 PM

OK, so I fixed the problem, 1 of the BIOS wires was still touching two pads. I now have video again, but now I am getting a RSOD when I try to use the Hacked Firmware upgrade disk. The LED comes on for 1 second and then goes off and stays off, like its suppose to and I can get normal games to startup just fine. Any ideas?

**gameplaya376** · 11-12-2006,06:46 PM

one or more of the other points are no good ..

User Tag List

Thread: Crystal Chip 1.2 Installed, No Video

Tweet

LinkBack

Thread Tools

Display


	Would you like to get all the new info from PSX-Scene in your email each day? Subscribe to our Daily Digest! Want to learn more about the team keeping you up to date with the latest scene news? Read about them now! Check out our Developer bios, too!