The above video goes away if you are a member and logged in, so log in now!
My First PS2 Mod –
Wish I had read before I bought the DMS4 SE Lite, but anyways I just wanted everyone to know that with all the talk about this chip being a pos I got it to work. Notes that can help some people if they made the same mistake I made.
Installed on a V7,
The Directions I went from were garbage so I did it my way.
1. a spare EIDE Cable cut and used the wires off that.
2. Cat 5E Cable for the power and ground.
Notes: Made sure the ground was as short as possible, same with the power. Put chip as close to the ps2 bios as possible. Put electrical tape over mod chip, bios, and power wire. when putting back together make sure wires are clear from screw points. I found that consoledotcom's directions were terible. Why would they say have the wires as close to the board as possible and yet mount the mod chip so far away.