The above video goes away if you are a member and logged in, so log in now!
Please help -v7 matrix infinity
Please help -v7 matrix infinity –
I'm sorry, I cant english very well.
I installed matrix infinity But it isn't work fine.
when MI is disable(booting with start button),
I can play original game.
and MI config mode(triangle+circle) work fine.
But when MI is enable, I can't play ps2 original dvd
and ps2 backup dvd
and ps1 original games
and ps1 backup games
and MI firmware upgrade cd.any disc don't work.
only ps2 browser screen is accepted.
so I can't upgrade firmware.
I installed it twice,but it occured same problem.
what's problem? Please help me.
With your MI upgrade disk in, try holding reset for 3 seconds to force update...
If that doesn't work you may have a older chip which requires a special upgrade procedure, or you CDVD point's need to be redone...
thanks marcus21..so..what is older chip? how can i 'special upgrade procedure'?
where is cdvd point?;; please, more answer.
CDVD points are B,G,H and I. Not all of these points are being used because it depends on the version of your PS2. For instance V5 PAL and NTSC only use B and I. Just refer to the respective diagram of your PS2 version.
my ps2 board is gh-022 maybe v8.
I solder with this diagram
a ~ I points are resolded again, but same problem is occured.
I heared that some blue dot Infinity has problem somewhere. is it right?
my chip has blue dot on actel chip.
is my MI bad chip?
I had the same problem with a different PS2 version, and it was the 'H' point that wasn't right.
my ps2 is ntsc/j 39005. is 'H' point wrong in diagram?
which point is right? must 'H' point be disconected?
if so, is it same diagram as ntsc/usa or pal?
Is it an original infinity or clone ? You definitely need to connect H, maybe even G.
South Africa. Repairs, chips etc.
It is original infinity. I connected H point.
But What is G point used for?
G point is being used with V9/v10. Since your PS2 is a V8 so G point is not needed.