The above video goes away if you are a member and logged in, so log in now!
So here some Pic`s of my install....
Think it`s not poor, short GND + 3.3V....
I try to bridge the Diode on the Matrix.... It doesn`t help....
I have no more Idea`s...
Anyone have ????
try cleaing up ur bios points and all the points in ur second picture
you should really organize your wires if it doesnt work, they shouldnt cross more than two times and the crossing should be near the mod chip. use hot glue instead of electrical tape too or small strips of electrical tape since solder points shouldnt come out if it is a good solder
So ripped of the Matrix again...
Now i`ll install it again with Thick GND + 3.3V,
an try that the wires are not crossing too much...
We`ll see what happen...
I would not have believed that its so tricky to make an Infinity work in a V4...
Last edited by clemente; 11-13-2006 at 11:20 AM.
Iv done some reading here and it shows that a lot of people is having this problem with v4 and Matrix. Im one of them. I have tried all the tricks without good result.
I enclose a pic of my install. I have done a few v4 before without any problems. What is this problem caused of ? Why is it only Matrix that has this problem ?
I tried to switch my chip for a ghost2 without resolder any cables and it workes fine..
I then installed the matrix again but the result is a black screen when I press the power fast. If I hold power it boots up but doesnt read anything.
I have tried to desolder the points p-m one by one. The Ps2 works like a charm when any of these points are desoldered.
Im really starting too loose patiens here.