HELP!!!!! I attempted to mod my V9 and I get blank screen!
:( I have a Matirx Infinity Green dot and have soldered it into my V9 black console. I followed the official diagram, but after trying the 'normal' ABGI points and lifting one of the big microchip's legs off the board, I used the alternate points instead. I tried to solder this leg back on, but it still is at a funny angle.:oops: Have I ruined the PS2's motherboard altogether? Please tell me where the most common places are for solder bridges to cause a blank screen, too. I think it may be a combination of problems. It switches on, the drive will open and shut but not read. It will reset and the fan works fine. I have used enough insulation tape to rival an eskimo's fur coat.
SO WHAT IS THE FLIPPIN' MATTER WITH IT?!! :rant:
(sigh) sorry. Please help if you can.