The above video goes away if you are a member and logged in, so log in now!
first install ..... need some help
first install ..... need some help –
ok jsut finished installing my first MI i think its an orange dot and its flashed with 1.75, had to re do the wires twice to get it to work right.
went into a v4R
ok before i installed it the dvd worked fine now it dosent work at all, it will try to spin twice then give up.
everytime i boot the ps2 i have to configure it each time.
theres no boot up sound, and after i leave the ps2 running for a while i get some strange C64 sounds out of it
any help to fix these problems would help... and yes i have used the search button
it sounds like an install problem, either a loose connection, a wrong connection or a shorted connection, recheck all these and if no go find a camera and take a pic and post here, we may see the problem straight away
going to shorten the wires to points A,B,I would this help correct the problem?
resolder those points ( A,B,I ) , that does sound like they are the problem .
ok p was loose which i think is what was causing the dvd not to work correct me if im wrong, all the points onj the chip are showing continuity to the board but i keep having to redo the system configuration everytime i reboot the ps2
undo A,B,I and resolder them . make sure all solder points are good . and the ps2 battery is pluged in .
no its plugged in so im thinking its dead
EDIT: just tested my battery and its fine, the config was saving fine before chip was installed
Last edited by AciDBoy; 01-18-2006 at 11:41 AM.
o resoldered A,B,I and still nothing so im giving up on installing this chip desoldering it off the board and finding a local miami, FL installer
the help was awesome guys, jsut finished rewireing the chip again and shes running awesome thanks again