The above video goes away if you are a member and logged in, so log in now!
Alternate point for Y –
Hello, Im installing MI on V15 GH051-51 board.
Other points are fine but Y point is too hard for me.
Does anyone knows alternate point for Y for GH051-51 board.??
Thank you very much!
Hmm. I don't think there is an alternate point for Y.
If your brave enough try to solder with the following instructions:
Be extra careful not to bridge the neighboring pins. The way I used to do controller pins(the safest way) is using 2 razor blades wedging between the pins in a v shaped pattern then the wire would approach the pin from the direction of the controller (from the top down) doing it the other way would make it more difficult since the pin legs are even closer together, bridging them would be very difficult to desolder.
If you do bridge them, not to worry, use a desoldering braided wick.
Last edited by d3xion; 01-14-2007 at 07:53 PM.
GREATER TORONTO AREA PS2 PRO INSTALLER
Free pickups in Scarborough, Richmond Hill, Markham Area! Servicing all of Canada.
- Crystal Chip 2.0 Pro for any v1-v15 PS2 $84 CAD with Lifetime Installation Warranty